ADL200 MID Certificate Single Phase Din Rail Energy Meter

ADL200 din rail energy meter adopts DIN35mm din rail installation with LCD display,it can measure electric parameters and has energy pulse output, RS485 communication,which has the advantages of small size, high precision, good reliability and convenient installation.

GET A QUOTE CONTACT US

Fast And Safe Logistics
Sample Available

ADL200 CE-ADL200 EAC-ADL200 MID-ADL200

ADL200

Rated Voltage: AC220V

Rated Current: 10(80)A

RS485(MODBUS-RTU) Communication

LCD Display; 35mm DIN Rail Installation

Multi-tariff: 4 Tariff Rates (Spike, Peak, Valley and Flat kWh)

MID Certificated

Functions

Parameters

Voltage	Rated voltage	AC 220V
	Rated frequency	50Hz
	Consumption	<10VA
Current	Maximum current	100A
	Starting current	0.01A
	Consumption	<1VA
Measurement performance	Accuracy	kWh Class 0.5
Measurement performance	Range	0~9999999999.99kWh
Clock	Accuracy	Error ≤0.5s/d
Active pulse	Width	80±20ms
Active pulse	Constant	1000imp/kWh,10000imp/kWh
Communication	Interface	RS485
Communication	Protocol	Mod bus-RTU
Temperature range	Work	-25°C~55°C
Temperature range	Storage	-40°℃~70°C
Humidity		≤95%(No condensation)
Altitude		<2000m

Display

Dimension

Note：The torque of direct connect should not be greater than 4.0N·m.

Front Panel

① Enter-wire
② Brand
③ Panel
④ Up Button
⑤ Down Button
⑥ Pluse Output
⑦ Model
⑧ Set Button
⑨ Out-wire

Network

Installation

FAQ

Q:The display power or energy count is inaccurate after the meter powered on.

A:Switch the meter display interface to the power (active power P, power factor λ) interface, and check whether the power display is negative or not.And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current The incoming wire must be the same as the incoming wire end of the meter), and consistent with the wiring diagram on the meter.

Q:It cannot communicate with the host computer normally after the instrument powered on.

A:1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V .

2. Check whether the communication wiring method is correctly wired according to the wiring diagram (that is, the communication terminal A/B of the instrument must be connected with Corresponding to communication serial port A/B);